|
Package sealing device |
|
|
Sterilization in an autoclave is the safest way for prevention
of infections. After sterilization, however, care must be taken
that instruments are not contaminated again. The MELAseal®100
and MELAseal®101
Package Sealing Devices can effectively seal sterilized
instruments so that they are stored while being safely protected
against contamination. Without great physical effort, these two
models produce optimal sealing seams 10 mm wide, with precise
sealing pressure. The german standard DIN 58953 specifies
sealing seams at least 8 mm wide. The working table is now
integrated in the housing of the device.
|
|
|
|
|
|
|
After the operator switches on the power to this device, it
takes approx. 2 minutes until the cold unit heats up to
operating temperature. When the signal lamp goes off, this means
that the MELAseal®100
-economic is in the ready mode and can go to work. When the
operator turns the crank, this presses the pressure bar against
the heated aluminium rail. After only 2 seconds, the
sterilization wrapper has been properly sealed in accordance
with relevant standards, with a sealing seam of 10 mm width.
The integrated cutter cuts off bags / wrappers to the required
length during the sealing procedure. These wrappings can be more
economically processed than can finished plastic-film bags.
|
Technical data: |
(dimensions are for width
×
height
×
depth) |
|
MELAseal
®
100 |
41 x
22 x 15 cm |
|
With reel dispenser "standard" and MELAfol®
- rolls |
41 x
45 x 28 cm |
|
With reel dispenser "advanced" and MELAfol
®
- rolls |
41 x
27 x 41 cm |
|
230 Volt, 50 Hz, 510 W |
|
|
|
|
|
|